1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.



2. Disconnect the crankshaft position (CKP) sensor harness connector.
3. Remove the CKP sensor retaining bolt.
4. Remove the CKP sensor from the engine block.

Note: Inspect the sensor O-ring for the following conditions:

Replace the O-ring if necessary. Lubricate the new O-ring with engine oil before installation.

Caution: Refer to Fastener Caution in the Preface section.




1. Install the CKP sensor into the engine block. Tighten the bolt to 10 N·m (89 lb in).
2. Install the CKP sensor retaining bolt.
3. Connect the CKP sensor harness connector.
4. Lower the vehicle.
5. Perform the Crankshaft Position System Variation Learn.