GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Isuzu 🢒 2006 🢒 Ascender - 4WD 🢒 General Information 🢒 General Information 🢒 Differential Side Bearings Replacement

Tools Required

    • J 8092 Universal Driver Handle - ¾ in - 10
    • J 21784 Side Bearing Installer
    • J 22888-D Side Bearing Puller Kit
    • J 45231 Differential Side Bearing Installer
    • J 29710 Differential Side Bearing Installer
    • J 36597 Side Bearing Puller Pilot - 9.25 Inch Axle

Removal Procedure
  1. Remove the differential. Refer to Differential Replacement .

    2. Object Number: 680400 Size: SH
  2. Remove the differential side bearings by performing the following steps:
    3. 2.1. Install the differential assembly in a vise.
    2.2. Install the J 22888-20A  (2) and the J 8107-2 , 8.0 inch axle, or the J 8107-4 , 8.6 inch axle, or the J 36597 9.5 inch axle (1), as shown.
    2.3. Remove the differential side bearings using the J 22888-20A .
  3. Remove the differential assembly from the vise.

Installation Procedure

    Object Number: 651740 Size: SH
  1. Install the differential side bearings by doing the following:
    2. 1.1. In order to protect the differential case, install the J 8107-2 , 8.0 inch axle, or the J 8107-4 , 8.6 inch axle, or the 9.5 inch axle, in the case on the side opposite the bearing installation.
    1.2. Install the J 45231 , 8.0 inch axle, or the J 21784 , 8.6 inch axle (2), or the J 29710 for the 9.5 (2) inch axle and the J 8092  (1) onto the differential case bearing as shown.
    1.3. Drive the bearing onto the case using the J 45231 , 8.0 inch axle, or the J 21784 , 8.6 inch axle (2) and the J 8092  (1).
  2. Install the differential. Refer to Differential Replacement .