GM Service Manual Online
For 1990-2009 cars only

Step

Action

Yes

No

Schematic Reference: Outside Rearview Mirror Schematics

Connector End View Reference: Power Door Systems Connector End Views

1

Did you perform the Diagnostic System Check - Vehicle?

Go to Step 2

Go to Diagnostic System Check - Vehicle in Vehicle DTC Information

2

  1. Turn ON the ignition, with the engine OFF.
  2. Activate the mirror fold switch in the extend and retract positions.

Do the outside rearview mirrors extend and retract with the corresponding switch activation?

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

Go to Step 3

3

Are both folding mirrors inoperative?

Go to Step 3

Go to Step 7

4

  1. Install a scan tool.
  2. Monitor the mirror select switch and the Mirror Switch Horizontal Data parameters.
  3. Activate fold from the mirror select switch.
  4. Activate the extend and retract functions from the mirror horizontal switch.

Do all of the data parameters change with the corresponding switch activations?

Go to Step 8

Go to Step 5

5

Do any of the data parameters change with the corresponding switch activations?

Go to Step 10

Go to Step 6

6

  1. Connect a test lamp to a good ground.
  2. Backprobe the switch power circuit at the power mirror switch harness connector.

Does the test lamp illuminate?

Go to Step 10

Go to Step 8

7

  1. Install a scan tool.
  2. With the scan tool, command the inoperative mirror to retract and extend.

Does the mirror move with the corresponding scan tool command?

Go to Step 11

Go to Step 9

8

Inspect for poor connections at the driver door module (DDM). Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 16

Go to Step 12

9

Inspect for poor connections at the power mirror. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 16

Go to Step 13

10

Inspect for poor connections at the power mirror switch. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 16

Go to Step 14

11

Inspect for poor connections at the appropriate door module. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 16

Go to Step 15

12

Replace the DDM. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming.

Did you complete the repair?

Go to Step 16

--

13

Replace the power mirror. Refer to Outside Rearview Mirror Replacement

Did you complete the repair?

Go to Step 16

--

14

Replace the power mirror switch. Refer to Power Mirror Switch Replacement .

Did you complete the repair?

Go to Step 16

--

15

Replace the appropriate door module. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming.

Did you complete the repair?

Go to Step 16

--

16

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 3