For 1990-2009 cars only
Removal Procedure
- Lift up on the front edge of the switch panel in order to release the front retaining clip.
- Lift up on the rear edge of the switch panel in order to release the 2 rear retaining clips.
- If equipped, disconnect the electrical connectors from the driver door module (1).
- If replacing only the driver door module, remove the module from the door trim panel.
- Disconnect the remaining electrical connectors from the switch panel.
- If replacing only the switch panel, retain the driver door module for transfer.
- Remove the switch panel assembly from the vehicle
Installation Procedure
- Install the driver door module (1) to the door trim panel.
- Connect the electrical connector to the driver door module.
- If replacing the switch panel, connect the remaining electrical connectors.
- If replacing the driver door module, program the driver door module. Refer to Control Module References and Personalization Description and Operation .
- Install the switch panel to the door trim panel, ensuring the front and rear retaining clips are fully seated.
Important: When replacing the driver door module, the set up procedure must be performed.
