Removal Procedure
- Turn the engine OFF.
- Disconnect the negative battery terminal.
- Drain coolant below the level of the engine coolant temperature (ECT) sensor. Refer to Cooling System Draining and Filling.
- Disconnect the ECT sensor electrical connector (1).
- Carefully remove the ECT sensor (1).
Caution: Use care when handling the coolant sensor. Damage to the coolant sensor will affect the operation of the fuel control system.
Warning: Refer to Battery Disconnect Warning in the Preface section.
Installation Procedure
- If installing the original sensor or a new sensor without sealant, apply thread sealer P/N 12346004 or equivalent.
- Install the ECT sensor and tighten to 16 N·m (12 lb ft).
- Connect the ECT electrical connector (1).
- Connect the negative battery terminal.
- Refill the engine coolant. Refer to Cooling System Draining and Filling.
Caution: Use care when handling the coolant sensor. Damage to the coolant sensor will affect the operation of the fuel control system.
Caution: Replacement components must be the correct part number for the application. Components requiring the use of the thread locking compound, lubricants, corrosion inhibitors, or sealants are identified in the service procedure. Some replacement components may come with these coatings already applied. Do not use these coatings on components unless specified. These coatings can affect the final torque, which may affect the operation of the component. Use the correct torque specification when installing components in order to avoid damage.
Caution: Refer to Fastener Caution in the Preface section.
