GM Service Manual Online
For 1990-2009 cars only

Special Tools

J 24319-B Steering Linkage and Tie Rod Puller

Removal Procedure

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation .

  3. Object Number: 687432  Size: SH
  4. Remove and discard the outer tie rod retaining nut.

  5. Object Number: 643351  Size: SH

    Notice: Do not attempt to disconnect a steering linkage joint by driving a wedge between the joint and the attached part. Seal damage may result which will cause premature failure of the joint.

  6. Disconnect the outer tie rod from the steering knuckle using J 24319-B .

  7. Object Number: 687434  Size: SH
  8. Loosen the jam nut (1) and remove the outer tie rod (2) from the inner tie rod (3).
  9. Do not reuse the jam nut.

  10. Inspect the shaft for bent or damaged threads.
  11. Clean the tapered surface of the steering knuckle.

Installation Procedure


    Object Number: 687434  Size: SH
  1. Lubricate the inner tie rod (3) threads with a suitable chassis lubricant before installing the outer tie rod (2).
  2. Install the new jam nut (1) to the outer tie rod (2).
  3. Install the outer tie rod (2) to the inner tie rod (3).

  4. Object Number: 687435  Size: SH
  5. Install the outer tie rod to the steering knuckle.
  6. Notice: Refer to Fastener Notice in the Preface section.

  7. Install the new outer tie rod retaining nut.
  8. Tighten
    Tighten the outer tie rod retaining nut to 57 N·m (42 lb ft).

  9. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  10. Lower the vehicle.
  11. Adjust the front toe. Refer to Front Toe Adjustment .