GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Holden 🢒 2009 🢒 WM Sedan 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Liquefied Petroleum Gas Control Module Replacement

Removal Procedure

    Caution: Refer to Safety Glasses Caution in the Preface section.

    Caution: Refer to Battery Disconnect Caution in the Preface section.

  1. Disconnect the battery ground cable. Refer to Battery Negative Cable Disconnection and Connection.

    2. Caution: Refer to Vehicle Lifting Caution in the Preface section.

  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
  3. Remove the left front wheel. Refer to Tire and Wheel Removal and Installation.
  4. Remove the left front wheel house liner. Refer to Front Wheelhouse Liner Replacement.

    5. Object Number: 1963332 Size: SH
  5. Disconnect the LPG control module electrical connector (1).

    6. Object Number: 1963331 Size: SH
  6. Remove the LPG control module to LPG control module bracket retaining nuts (1).
  7. Remove the LPG control module (2) from the vehicle.

Installation Procedure

    Object Number: 1963331 Size: SH
  1. Position the LPG control module (2) to the vehicle.

    2. Notice: Refer to Fastener Notice in the Preface section.

  2. Install the LPG control module to LPG control module bracket retaining nuts (1).

    3. Tighten
    Tighten the nuts to 5 N·m (44 lb  in).


    Object Number: 1963332 Size: SH
  3. Connect the LPG control module electrical connector (1).
  4. Install the left front wheel house liner. Refer to Front Wheelhouse Liner Replacement.
  5. Install the left front wheel. Refer to Tire and Wheel Removal and Installation.
  6. Connect the battery ground cable. Refer to Battery Negative Cable Disconnection and Connection.