Valve Rocker Arm Cover Removal - Right Side L98, LS2

1. Remove the spark plug leads (1).



2. Remove the ignition coil bracket retaining studs (2).
3. Remove the ignition coil and bracket assembly (1).



4. Remove the valve rocker arm cover retaining bolts (2) and valve rocker arm cover (1).




Important: The valve rocker arm cover gasket is a single use only component and must be replaced whenever the valve rocker arm cover is removed from the cylinder head.

5. Remove the valve rocker arm cover gasket (1).

Discard the valve rocker arm cover gasket (1).

Valve Rocker Arm Cover Removal - Right Side LS3

Important: Do not remove the oil fill tube from the cover unless service is required. If the oil fill tube has been removed from the cover, install a NEW tube during assembly.

1. Remove the spark plug wires (724).
2. Remove the ignition coil bracket studs (720).
3. Remove the ignition coil and bracket assembly (719).



4. Disconnect the ignition coil electrical connectors.
5. Remove the bolts (723), coils (722), and wire harness (721) from the bracket, as required.



6. Remove the valve rocker arm cover bolts (516) and cover (505).



7. Remove the gasket (504) from the cover.



8. Remove the oil fill cap (424) from the oil fill tube (423).
9. Remove the oil fill tube, as required.
10. Discard the oil fill tube (423) and O-ring (422).