DTC Descriptor
DTC C0569 00: System Configuration ErrorDiagnostic Fault Information
Perform the Diagnostic System Check - Tire Pressure Monitoring prior to using this diagnostic procedure.
Circuit/System Description
The remote function actuator (RFA) receives a radio frequency (RF) transmission from each tire pressure sensor. Each sensors RF transmission contains its own unique identification (ID) code that must be learned into the RFA memory. Once all four IDs have been learned and vehicle speed is 40 kph (25 mph) or greater the RFA continuously compares IDs in received transmission to its learned IDs to determine if all four sensors are present.
Conditions for Running the DTC
The ignition is ON.
Conditions for Setting the DTC
The RFA has not undergone the tire type and tire pressure selection setup procedure.
Action Taken When the DTC Sets
The instrument panel cluster (IPC) displays the SERVICE TIRE MONITOR warning message.
Conditions for Clearing the DTC
A current DTC will clear when the RFA has undergone the setup procedure.
Diagnostic Aids
A newly replaced RFA will set DTC C0569 on its initial ignition ON cycle. tire type and tire pressure selection setup must be performed. Refer to Tire Pressure Indicator Sensor Programming .
Reference Information
Schematic Reference
Tire Pressure Monitoring System Schematics .
Description and Operation
Tire Pressure Monitor Description and Operation
Scan Tool Reference
Special Tools Required
J-46079 Tire Pressure Monitor Diagnostic Tool
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure and Control Module References for RFA replacement, setup and programming.
