GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Holden 🢒 2008 🢒 WM Sedan 🢒 Brakes 🢒 Hydraulic Brakes 🢒 Wheel Drive Shaft Outer Joint and Boot Replacement

Removal Procedure

    Caution: Refer to Safety Glasses Caution in the Preface section.

    Caution: Refer to Vehicle Lifting Caution in the Preface section.

    Important: Outer constant velocity joint and axle shaft can not be separated and are replaced as a complete assembly.

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
  2. Remove the wheel drive shaft from the vehicle. Refer to Wheel Drive Shaft Replacement.
  3. Remove inner constant velocity joint and joint boot. Refer to Wheel Drive Shaft Inner Joint and Boot Replacement.
  4. Discard wheel drive shaft assembly.

Installation Procedure
  1. Install outer joint boot to NEW outer constant velocity joint and axle shaft assembly. Refer to Rear Wheel Drive Shaft Outer Joint Boot Replacement.
  2. Install the inner constant velocity joint and joint boot. Refer to Wheel Drive Shaft Inner Joint and Boot Replacement.
  3. Install the wheel drive shaft to the vehicle. Refer to Wheel Drive Shaft Replacement.
  4. Remove the safety stands.
  5. Lower the vehicle to the ground.