Circuit Description
When the ignition switch is turned to ON, the sensing and diagnostic module (SDM) will perform a turn-on test to diagnose critical malfunctions within the SDM itself.
Upon passing this test, ignition and deployment loop voltages are measured to ensure they are within the normal voltage ranges. The SDM monitors the voltages at the driver low and the passenger low to detect shorts to ground or voltage in the deployment loops.
DTC Descriptor
This diagnostic procedure supports the following DTC:
DTC 082 LH Side Impact Sensor Communication Invalid
Conditions for Running the DTC
Ignition voltage is within the normal operating voltage range.
Conditions for Setting the DTC
A communication error occurs between the SDM and the left side impact sensor.
Action Taken When the DTC Sets
The SDM commands the AIR BAG indicator ON.
Conditions for Clearing the DTC
The condition responsible for setting the DTC no longer exists and the scan tool Clear DTCs function is used.
Step | Action | Yes | No |
|---|---|---|---|
|
Caution: Refer to Sensing and Diagnostic Module Voltage after Ignition is Turned Off Caution in the Preface section. Caution: Refer to Sensing and Diagnostic Module Handling Caution in the Preface section. Schematic Reference: SIR Schematics Connector End View Reference: SIR Connector End Views | |||
1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | |
2 |
Is the air bag wiring damaged? | Go to Step 3 | Go to Step 4 |
3 | Replace the air bag wiring. Did you complete the replacement? | Go to Step 6 | -- |
4 |
Is DTC 082 still shown as a current fault? | Go to Step 5 | Go to Step 6 |
5 | Replace the SDM. Refer to Inflatable Restraint Sensing and Diagnostic Module Replacement. Did you complete the repair? | Go to Step 6 | -- |
6 |
Does the DTC reset? | Go to Step 2 | System OK |
