GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Holden 🢒 2007 🢒 Viva 🢒 HVAC 🢒 Heating, Ventilation, and Air Conditioning 🢒 Blower Motor Replacement

Removal Procedure

    Caution: Refer to Battery Disconnect Caution in the Preface section.


    Object Number: 1308289 Size: SH
  1. Disconnect the negative battery cable.
  2. Remove the glove box. Refer to Instrument Panel Storage Compartment Replacement .
  3. Remove the carpet to prevent stains.
  4. Disconnect the blower motor electrical connector and resistor connector.
  5. Remove the screws that secure the motor to the heater/air distributor case.

    6. Object Number: 1308290 Size: SH
  6. Remove the motor, the seal, and the shock mount pads from the heater/air distributor case by gently pulling the motor straight down and out.

Installation Procedure

    Object Number: 1308291 Size: SH
  1. Install the blower motor and the seal with the shock mount pads in the heater/air distributor case. Hold the blower motor in position.

    2. Notice: Refer to Fastener Notice in the Preface section.

  2. Install the screws to secure the blower motor to the heater/air distributor case.

    3. Tighten
    Tighten the blower motor retaining screws to 1.2 N·m (11 lb in).

  3. Connect the blower motor electrical connector and resistor connector.
  4. Connect the negative battery cable.
  5. Confirm that the blower motor operates properly.
  6. Replace the glove box. Refer to Instrument Panel Storage Compartment Replacement .