For 1990-2009 cars only
Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
Circuit/System Description
Ignition 1 voltage is supplied directly to the water in fuel lamp. The engine control module (ECM) turns the water in fuel lamp ON by sending a request to the instrument panel cluster (IPC) via the CAN communication circuit. The ECM monitors the amount of water in the fuel with a sensor located in the fuel filter assembly. When the water in the fuel is above an acceptable level, the ECM sends a request to illuminate the water in fuel lamp.
Reference Information
Schematic Reference
Connector End View Reference
Description and Operation
Instrument Cluster Description and Operation
Electrical Information Reference
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Verification
- Ignition ON, observe the DTC information with a scan tool. Verify that DTC U0100, U0155, or U2105 is not set.
- Command the water in fuel lamp ON and OFF with a scan tool. The water in fuel lamp should respond to the scan tool commands.
| ⇒ | If any of the DTCs are set, refer to Diagnostic Trouble Code (DTC) List - Vehicle. |
| ⇒ | If the water in fuel lamp does not respond properly, replace the IPC. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the repair.
| • | Control Module References for Instrument Panel Cluster replacement, setup, and programming |
