GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

    Caution: Refer to Battery Disconnect Caution in the Preface section.


    Object Number: 1820528  Size: SH

    Caution: Gasoline or gasoline vapors are highly flammable. A fire could occur if an ignition source is present. Never drain or store gasoline or diesel fuel in an open container, due to the possibility of fire or explosion. Have a dry chemical (Class B) fire extinguisher nearby.

  1. Disconnect the negative battery cable.
  2. Disconnect the common rail pressure sensor connector.
  3. Disconnect the common rail regulator connector.
  4. Disconnect the common rail return hose.
  5. Remove the engine wiring guide from the intake manifold.

  6. Object Number: 1820511  Size: SH
  7. Remove the high pressure fuel pipes. Refer to Fuel Injector Fuel Feed Pipe Replacement .

  8. Object Number: 1820530  Size: SH

    Important: Put a caps on the common rail pipe threads to avoid contamination from dust as soon as the fuel pipes are removed to prevent be clogged injectors.

  9. Remove the common rail assembly.

Installation Procedure

    Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 1820530  Size: SH

    Notice: 

       • Use care when servicing the fuel system components, especially the fuel injector electrical connectors, the fuel injector tips, and the injector O-rings. Plug the inlet and the outlet ports of the fuel rail in order to prevent contamination.
       • Do not use compressed air to clean the fuel rail assembly as this may damage the fuel rail components.
       • Do not immerse the fuel rail assembly in a solvent bath in order to prevent damage to the fuel rail assembly.

    Important: Do not reuse the fuel pipes. If reused, the contaminated pipes may be damage the injectors or cause leaks from the pipes.

  1. Install the common rail assembly.
  2. Tighten
    Tighten the common rail retaining bolts to 25 N·m (18.4 lb in).


    Object Number: 1820528  Size: SH
  3. Install the fuel pipes to the common rail. Refer to Fuel Injector Fuel Feed Pipe Replacement .
  4. Connect the common rail pressure sensor connector.
  5. Connect the common rail regulator connector.
  6. Prime the fuel system. Refer to Fuel System Priming .