GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Holden 🢒 2008 🢒 Barina 🢒 Suspension 🢒 Front Suspension 🢒 Stabilizer Shaft Insulator Replacement

Removal Procedure
  1. Raise and support the vehicle. Use jacks in order to support the front suspension crossmember. Refer to Lifting and Jacking the Vehicle.

    2. Object Number: 1241979 Size: SH
  2. Lower the front suspension crossmember slightly in order to access the stabilizer shaft insulator brackets. Refer to Front Suspension Crossmember Replacement.
  3. Remove the bolts from the stabilizer shaft insulator brackets.
  4. Remove the brackets from the stabilizer shaft insulators.
  5. Remove the stabilizer shaft insulators.
  6. Clean the stabilizer shaft.

Installation Procedure
  1. Install the insulators to the stabilizer shaft.
  2. Install the brackets to the stabilizer shaft insulators.

    3. Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 1241980 Size: SH
  3. Install the bolts to the stabilizer shaft insulator brackets.

    4. Tighten
    Tighten the stabilizer shaft insulator bracket bolts to 25 N·m (18 lb ft).

  4. Raise and install the front suspension crossmember. Refer to Front Suspension Crossmember Replacement.
  5. Remove the jacks and lower the vehicle.