For 1990-2009 cars only
Removal Procedure
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Remove the right front tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
- Remove the power steering pump. Refer to Power Steering Pump Replacement in Power Steering System.
- Disconnect the electrical connector from the speed sensor.
- Remove the speed sensor / vent hose bolt (3) from the transfer case.
- Reposition the pinion housing vent hose (2) and mounting bracket away from the speed sensor bolt boss.
- Remove the speed sensor (1).
- Remove O-ring from the speed sensor, if necessary. The O-ring may be reused if it is not cut or damaged.
Installation Procedure
- Install the O-ring to the speed sensor, if removed.
- Install the speed sensor (1) to the transfer case.
- Position the pinion housing vent hose (2) and mounting bracket to the speed sensor bolt boss.
- Install the speed sensor bolt (3) to the transfer case.
- Connect the electrical connector to the speed sensor.
- Install the power steering pump. Refer to Power Steering Pump Replacement in Power Steering System.
- Install the right front tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
- Lower the vehicle.
Notice: Refer to Fastener Notice in the Preface section.
Tighten
Tighten the bolt to 30 N·m (22 lb ft).
