Circuit Description
The internal fault detection is handled by the instrument panel cluster (IPC).
DTC Descriptor
This diagnostic procedure supports the following DTC:
DTC B0935 Compass Sensor Circuit Open
Conditions for Running the DTC
The IPC monitors the analog input value at power up.
Conditions for Setting the DTC
The IPC does not detect the compass sensor. This may be due to an open circuit.
Action Taken When the DTC Sets
The DTC will be set and stored in non-volatile memory.
Conditions for Clearing the DTC
| • | The DTC becomes history when the driver information center (DIC) no longer detects a failure. |
| • | The history DTC clears after 100 fault free ignition cycles. |
| • | The DIC receives the clear code command from the scan tool. |
Step | Action | Yes | No |
|---|---|---|---|
Schematic Reference: Instrument Cluster Schematics Connector End View Reference: Instrument Panel, Gages, and Console Connector End Views | |||
1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | Go to Diagnostic System Check - Vehicle in Vehicle DTC Information |
2 | Replace the instrument panel cluster (IPC). Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming. Did you complete the replacement? | Go to Step 3 | -- |
3 |
Does the DTC reset? | Go to Step 2 | System OK |
