Tools Required

J 39363 Supercharger Actuator Adjuster

1. Disconnect the negative battery cable.
2. Disconnect the vacuum hoses from the bypass valve actuator.
3. Remove the boost control solenoid. Refer to Boost Control Solenoid Replacement in Engine Controls.



4. Remove the bypass valve actuator mounting bolts and rotate the bypass valve actuator until the rod disengages the lever.

1. Install tool J 39363 onto actuator.

Important: When installing the bypass valve actuator to the supercharger, be sure to rotate the assembly until the bypass valve shaft lever comes in contact with the stop block.

2. Rotate the actuator until the rod engages the lever.
3. Install the bypass valve actuator mounting bolts.

Tighten
Bolts to 25 N·m (18 lb ft).

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

4. Remove J 39363 .
5. Install the boost control solenoid. Refer to Boost Control Solenoid Replacement in Engine Controls.
6. Connect the vacuum hoses to the bypass valve actuator.
7. Connect the negative battery cable.