Schematic Reference: Instrument Cluster Schematics

Did you perform the IPC Diagnostic System Check?

Go to Step 2

Go to Diagnostic System Check - Instrument Cluster

1. Install a scan tool.
2. Turn the ignition ON, with the engine OFF.
3. With a scan tool, observe the Engine Oil Level parameter in the PCM data 2 list.

Does the Engine Oil Level parameter display OK?

Go to Step 3

Go to Step 4

Does the low engine oil level indicator remain illuminated after the displays test?

Go to Step 10

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

1. Turn the ignition OFF.
2. Disconnect the PCM connector C2.
3. Turn the ignition ON, with the engine OFF.
4. Connect a test lamp between the signal circuit of the engine oil level switch at the PCM and battery positive voltage. Refer to Circuit Testing in Wiring Systems.

Does the test lamp illuminate?

Go to Step 7

Go to Step 5

Test the signal circuit of the engine oil level indicator switch for an open, or for a short to voltage. Refer to Circuit Testing and to Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 12

Go to Step 6

Test the ground of the engine oil level indicator switch for an open. Refer to Circuit Testing and to Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 12

Go to Step 8

Inspect for poor connections at the PCM. Refer to Testing for Intermittent Conditions and Poor Connections and to Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 12

Go to Step 9

Inspect for poor connections at the engine oil level switch. Refer to Testing for Intermittent Conditions and Poor Connections and to Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 12

Go to Step 11

Important: Program the replacement PCM.

Replace the PCM. Refer to Powertrain Control Module Replacement in Engine Controls.

Did you complete the replacement?

Go to Step 12

--

Important: Perform the compass calibration and variance procedure on the replacement IPC.

Replace the IPC. Refer to Instrument Cluster Replacement .

Did you complete the replacement?

Go to Step 12

--

Replace the engine oil level switch. Refer to Engine Oil Level Sensor and/or Switch Replacement in Engine Mechanical.

Did you complete the replacement?

Go to Step 12

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 2