GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

  1. Remove the upper I/P trim pad. Refer to Instrument Panel Upper Trim Pad Replacement in Instrument Panel, Gages and Console.

  2. Object Number: 295297  Size: SH
  3. Disconnect the recirculation actuator electrical connector.

  4. Object Number: 872107  Size: SH
  5. Remove the mounting screws from the recirculation actuator.
  6. Remove the recirculation actuator.

Installation Procedure


    Object Number: 872107  Size: SH
  1. Install the recirculation actuator.
  2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the recirculation actuator mounting screws.
  4. Tighten
    Tighten the screws to 1.6 N·m (14 lb in).


    Object Number: 295297  Size: SH
  5. Connect the recirculation actuator electrical connector.
  6. Install the upper I/P trim pad. Refer to Instrument Panel Compartment Replacement in Instrument Panel, Gages and Console.