Floor Console Auxiliary Air Outlet Replacement Aztek

1. Remove the rear section of the console trim panel. Lift up and towards the rear to release the clips.
2. Disconnect the rear power supply electrical connector.
3. Remove the rear duct screws.
4. Remove the rear duct from the console.
5. If you are replacing the center section of the console duct, perform the following procedure:

5.1.	Remove the center console. Refer to Front Floor Console Replacement in Instrument Panel, Gages, and Console.

5.2.	Rotate the console so that the bottom side is up.

5.3.	Remove the center duct screws.

5.4.	Remove the center console duct from the console.

1. If you are replacing the center section of the console duct, perform the following procedure:

1.1.	Install the center console duct to the console.

Notice: Refer to Fastener Notice in the Preface section.

1.2.	Install the center console duct screws.

Tighten
Tighten the screws to 1.5 N·m (13 lb in).

1.3.	Install the center console. Refer to Front Floor Console Replacement in Instrument Panel, Gages, and Console.

Important: Align the rear power supply harness away from the center mounting stud of the rear duct.

2. Install the rear duct to the console.
3. Install the rear duct screws.

Tighten
Tighten the screws to 1.5 N·m (13 lb in).

4. Connect the rear power supply electrical connector.
5. Install the rear section of the console trim panel.

Floor Console Auxiliary Air Outlet Replacement Rendezvous

1. Remove the rear trim plate from the console. Refer to Console Rear Trim Plate Replacement in Instrument Panel, Gages, and Console.



2. Pull the air duct from the trim plate.



3. Turn the air deflector down. Squeeze and push on the deflector from the rear of the trim plate



4. Remove the air deflector.

1. Install the air deflector to the trim plate from the front.
2. Push on the deflector until the deflector is firmly seated.
3. Verify proper movement of the air deflector.



4. Push the air duct onto the trim plate until the air duct is firmly seated.
5. Install the trim plate to the console. Refer to Console Rear Trim Plate Replacement in Instrument Panel, Gages, and Console.