Instrument Panel Accessory Trim Plate Replacement Aztek

1. Position the floor shifter in the Drive position.
2. Remove the front floor console. Refer to Front Floor Console Trim Plate Replacement .
3. Remove 2 screws from the lower trim plate.



4. Remove the instrument panel (I/P) accessory trim plate by releasing the retainers.

1. Align the retainers on the I/P accessory trim plate to the slots in the I/P.
2. Install the retainers into the slots until the retainers are fully seated.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the 2 screws to the lower trim plate.

Tighten
Tighten the screws to 2 N·m (18 lb in).

4. Install the front floor console. Refer to Front Floor Console Trim Plate Replacement .