For 1990-2009 cars only
Removal Procedure
- Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Remove the tires and wheels. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
- Remove the brake rotor. Refer to Rear Brake Rotor Replacement in Disc Brakes.
- Remove the antilock brake system (ABS) electrical connector from the wheel speed sensor, if equipped.
- Remove the park brake cable from the park brake actuator. Refer to Parking Brake Rear Cable Replacement in Park Brake.
- Remove the mounting bolts from the rear bearing/hub.
- Remove the wheel bearing/hub and park brake assembly from the knuckle.
- Remove the park brake actuator from the rear wheel bearing/hub. Refer to Parking Brake Actuator Replacement in Park Brake.
Important: The wheel bearing in the rear wheel hub is integrated into one unit. The hub is non-serviceable. If the hub and/or bearing is damaged, replace the complete hub and bearing assembly.
Installation Procedure
- Install the park brake actuator to the rear wheel bearing/hub. Refer to Parking Brake Actuator Replacement in Park Brake.
- Install the wheel bearing/hub and park brake assembly to the knuckle.
- Install the wheel bearing/hub-to-knuckle bolts.
- Install the park brake cable to the park brake actuator. Refer to Parking Brake Rear Cable Replacement in Park Brake.
- Install the ABS electrical connector to the wheel speed sensor , if equipped.
- Install the brake rotor. Refer to Rear Brake Rotor Replacement in Disc Brakes.
- Install the tires and wheels. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
- Lower the vehicle.
Notice: Refer to Fastener Notice in the Preface section.
Tighten
Tighten the bolts to 75 N·m (55 lb ft).
