GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

  1. Remove the front floor console. Refer to Front Floor Console Replacement in Instrument Panel, Gages, and Console.

  2. Object Number: 410372  Size: SH
  3. Remove the HVAC control module mounting screws.

  4. Object Number: 410369  Size: SH
  5. Disconnect the electrical connector.
  6. Remove the HVAC control module.

Installation Procedure


    Object Number: 410369  Size: SH

    Important: The key should be in the off position when connecting the electrical connectors to ensure proper calibration.

  1. Connect the electrical connectors.

  2. Object Number: 410372  Size: SH
  3. Install the HVAC control module.
  4. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  5. Install the HVAC control module mounting screws.
  6. Tighten
    Tighten the screws to 2 N·m (18 lb in).

  7. Install the front floor console. Refer to Front Floor Console Replacement in Instrument Panel, Gages, and Console.
  8. Important: Do not adjust any controls on the HVAC control module while the HVAC control module is calibrating. If interrupted improper HVAC performance will result.

  9. Start the engine and run for one minute.