Heater Inlet Pipe Adapter Replacement 3.8L

Tools Required

J 38185 Hose Clamp Pliers

1. Drain the cooling system. Refer to Cooling System Draining and Filling in Engine Cooling.
2. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement in Engine Mechanical-3.8L.



3. Disconnect the heater inlet hose from the pipe adapter.
4. Use J 38185 in order to reposition the heater hose clamp.



5. Remove the heater pipe adapter mounting bolt.
6. Remove the heater pipe adapter.

1. Lubricate the O-ring.



2. Install the heater pipe adapter.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the heater inlet pipe adapter mounting bolt.

Tighten
Tighten the heater inlet pipe adapter bolt to 6 N·m (53 lb in).




4. Connect the inlet hose to the heater pipe adapter.
5. UseJ 38185 in order to reposition the heater core hose clamp.
6. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement in Engine Mechanical-3.8L.
7. Refill the cooling system. Refer to Cooling System Draining and Filling in Engine Cooling.