Circuit Description
The electronic brake control module (EBCM) performs several self-tests for any internal problems which may affect proper operation.
DTC Descriptor
This diagnostic procedure supports the following DTC:
DTC C0550 Electronic Control Unit (ECU) Performance
Conditions for Running the DTC
The ignition is ON.
Conditions for Setting the DTC
The EBCM detects an internal malfunction.
Action Taken When the DTC Sets
The following actions may occur:
| • | The EBCM disables the ABS/dynamic rear proportion (DRP). |
| • | The ABS indicator turns ON. |
| • | The brake warning indicator turns ON. |
Conditions for Clearing the DTC
Certain failures that may cause this DTC to set cannot be cleared. Other failures that may cause this DTC to set may be cleared, at least temporarily, by using the scan tool Clear DTCs function.
Diagnostic Aids
Replace the EBCM if this DTC continues to set intermittently.
Step | Action | Yes | No |
|---|---|---|---|
1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | |
2 | Use a scan tool in order to clear the DTCs. Can the DTC be cleared? | Go to Step 3 | Go to Step 4 |
3 |
Does the DTC reset? | Go to Step 4 | Go to Diagnostic Aids |
4 |
Important: Following electronic brake control module (EBCM) replacement, use the scan tool to perform the Tire Size Calibration procedure. Replace the EBCM. Refer to Control Module References . Did you complete the replacement? | Go to Step 5 | -- |
5 |
Does the DTC reset? | Go to Step 3 | System OK |
