For 1990-2009 cars only
Tools Required
| • | J 41816 Crankshaft Balancer Remover |
| • | J 41816-2 Crankshaft End Protector |
| • | J 42386-A Flywheel Holding Tool |
- Install the J 42386-A and bolts.
- Remove the crankshaft balancer bolt.
- Use the J 41816 and the J 41816-2 in order to remove the crankshaft balancer.
- Remove the J 42386-A and bolts.
Notice: Refer to Fastener Notice in the Preface section.
Important:
• Do not use the crankshaft balancer bolt again. Install a NEW crankshaft
balancer bolt during final assembly. • Make sure that the teeth of the flywheel holding tool mesh with the
teeth of the engine flywheel.
Use one M10 - 1.5 x 120 mm and one M10 - 1.5 x 45 mm bolt for proper tool operation.
Tighten
Tighten the J 42386-A
bolts
to 50 N·m (37 lb ft).
Do not discard the crankshaft balancer bolt. The balancer bolt will be used during the balancer installation procedure.
