Removal Procedure
- Disable the SIR system. Refer to SIR Disabling and Enabling or SIR Disabling and Enabling .
- Move the seat to the full forward position.
- Remove the seat back panel cover (2) from the seat (1) by lifting up the bottom of the panel and pulling the bottom away from the seat in order to release the hook retainers.
- Remove the 2 fasteners (1) from the inflatable restraint side impact inflator module (top and bottom fasteners only).
- Remove the inflatable restraint side impact module (1) from the seat (2).
- Fully deploy the module before disposal. If the module was replaced under warranty, fully deploy and dispose of the module after the required retention period. Refer to Inflator Module Handling and Scrapping .
- Remove the connector position assurance (CPA) (4) from the inflatable restraint side impact module electrical connector (5).
- Disconnect the electrical connector (5) from the inflatable restraint side impact module (1).
Caution: Refer to SIR Inflator Module Handling and Storage Caution in the Preface section.
Caution: Following the deployment of a side impact air bag, inspect the following
parts for damage. Replace these parts if necessary:
• The seat cushion frame • The seat recliner, if equipped • The seat adjuster • The seat back frame
Important: Removal of the right or the left inflatable restraint side impact inflator module (seat side air bag) uses the same procedure.
Removal of the seat back panel (2) will expose the fasteners that attach side air bag to seat (1).
Important: Do not remove the center fastener from the side impact module. If the center fastener is removed this could cause the side air bag to deploy improperly, or unnecessary air bag system repairs.
Installation Procedure
- Install a new inflatable restraint retainer. Push in the fastener (6) to the inflatable restraint side impact module (1) when replacing the module.
- Install a new retainer fastener (3) to the seat (2) when replacing the module.
- Connect the electrical connector (5) to the inflatable restraint side impact module (1).
- Install the CPA (4) to the electrical connector (5) on the inflatable restraint side impact module.
- Install the inflatable restraint side impact module (1) to the seat (2).
- Install the 2 fasteners (1) to the inflatable restraint side impact module.
- Install the seat back panel (2) to the seat (1) by sliding the top of the panel up into place and pushing the bottom of the panel in and then down until the hook retainers are secure.
- Install the seat to the original position.
- Enable the SIR system. Refer to SIR Disabling and Enabling or SIR Disabling and Enabling .
Important: After a deployment or replacement, both retainer fasteners (3,6) must be replaced in order to ensure the proper module positioning.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the nuts to 9 N·m (80 lb in).
