Schematic References: Outside Rearview Mirror Schematics and Door Control Module Schematics

Did you Perform the Door Systems Diagnostic System Check?

Go to Step 2

Go to Diagnostic System Check - Door Systems

Verify that the Power Mirrors Inoperative complaint is present.

Does the Power Mirror System operate as described in the Outside Mirror Description and Operation?

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

Go to Step 3

1. Install a scan tool.
2. Turn ON the ignition, with the engine OFF.
3. Observe the Driver Mirror Selectors parameter in the Driver Door Module, Inputs list.
4. Place the mirror select switch in the Left and then the Right mirror selections.

Did the Driver Mirror Selectors parameter indicate the appropriate mirror selection?

Go to Step 4

Go to Step 6

1. Observe the Driver Mirror Switches parameter in the Driver Door Module, Inputs list.
2. Operate the mirror position switch to the UP, DOWN, LEFT and RIGHT positions.

Did the Driver Mirror Switches parameter change from the Idle state to the UP, DOWN, LEFT, and RIGHT states as expected?

Go to Step 5

Go to Step 6

1. Disconnect the mirror harness connector C5 from the door module.
2. Connect a test lamp between the appropriate mirror motor control circuits at the door module pins.
3. Operate the mirror position switch in both directions of the inoperative axis.

Does the test lamp illuminate in both directions?

Go to Step 8

Go to Step 7

Inspect for a poor connections at the harness connector of the driver door switch assembly. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 12

Go to Step 11

Inspect for poor connections at the harness connector of the door module. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 12

Go to Step 10

Inspect for poor connections at the harness connector of the inoperative outside rear view mirror. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 12

Go to Step 9

Replace the inoperative outside rear view mirror. Refer to Power Mirror Replacement .

Did you complete the replacement?

Go to Step 12

--

Replace the door module of the inoperative mirror. Refer to Door Control Module Replacement - Front .

Did you complete the replacement?

Go to Step 12

--

Replace the driver door switch assembly. Refer to Front Door Switch Replacement .

Did you complete the replacement?

Go to Step 12

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 2