Caution: To avoid any vehicle damage, serious personal injury or death when major components are removed from the vehicle and the vehicle is supported by a hoist, support the vehicle with jack stands at the opposite end from which the components are being removed and strap the vehicle to the hoist.

1. Raise the vehicle.



2. Mark the hoses for installation on the EVAP canister.
3. Remove the EVAP vent hose (1).
4. Remove the fuel tank vapor hose (2).
5. Remove the purge hose (3).



6. Remove the nuts (2) from the EVAP canister.
7. Remove the EVAP canister (1) from the bracket by releasing tabs.

1. Install the EVAP canister on the bracket.
2. Install the EVAP canister assembly into the vehicle.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Assemble the EVAP canister to the underbody with the 3 nuts.

Tighten
Tighten the EVAP Canister nuts to 9 N·m (80 lb in).




4. Install the purge hose (3) to the EVAP canister.
5. Install the fuel tank vapor hose (2) EVAP canister.
6. Install the vent hose (1) to the EVAP canister
7. Lower the vehicle.