Caution: Refer to Brake Dust Caution in the Preface section.

Notice: Refer to Fastener Notice in the Preface section.

Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .

Preliminary Procedure

Remove the brake caliper mounting bracket. Refer to Rear Brake Caliper Bracket Replacement .

1

Rotor Retention Bolt

Tighten
12 N·m (106 lb in)

2

Brake Rotor

Tip

1. If removing the rotor to service the wheel bearing/hub, use the J 41013 , to clean the contact area of the rotor to the wheel bearing/hub.
2. If servicing the rotor, use the J 42450-A , to clean the contact area of the wheel bearing/hub.
3. If the brake rotor was removed and installed measure the lateral runout measurement (LRO). Refer to Brake Rotor Assembled Lateral Runout Measurement .
4. If the LRO measurement exceeds specifications, refer to Brake Rotor Assembled Lateral Runout Correction .
5. Burnish the pads and rotors. Refer to Brake Pad and Rotor Burnishing .