Preliminary Procedures

1. Remove the knee bolster panel. Refer to Driver Knee Bolster Replacement .
2. Disconnect the electrical connector for the brake pedal position sensor.

1

Nut (Qty: 2)

Notice: Refer to Fastener Notice in the Preface section.

Tighten
10 N·m (89 lb in)

2

Accelerator Pedal

Tip
Relocate accelerator pedal to the side.

3

Clip

4

Spacer

5

Nut (Qty: 4)

Tip

1. Lower the steering column. Refer to Steering Column Replacement .
2. You DO NOT have to remove the steering column from the vehicle. Lower the steering column to gain access to the mounting nuts for the brake pedal mounting bracket.

Tighten
30 N·m (22 lb ft)

6

Brake Pedal

Tip
Calibrate the brake pedal position sensor. Refer to Brake Pedal Position Sensor Calibration .