For 1990-2009 cars only
Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptor
DTC C0558 46: Calibration Data Not Programmed/Learned, vehicle configuration not programmedCircuit/System Description
The electronic brake control module (EBCM) must be programmed using SPS.
Conditions for Running the DTC
| • | Ignition ON. |
| • | Ignition voltage is greater than 10 volts. |
Conditions for Setting the DTC
The EBCM has not been programmed.
Actions Taken When DTC Sets
A DIC message and/or a warning indicator may be displayed.
Conditions for Clearing the DTC
| • | The condition for the DTC is no longer present. |
| • | The EBCM clears the history DTC when a current DTC is not detected in 40 consecutive drive cycles. |
Reference Information
Schematic Reference
Antilock Brake System Schematics
Connector End View Reference
Description and Operation
Electrical Information Reference
Scan Tool Reference
Control Module References for scan tool information.
Circuit/System Verification
Verify that DTC C0558 is not set.
| ⇒ | If the DTC is set, program the EBCM. If the DTC resets, replace the EBCM. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for EBCM replacement, setup, and programming
