Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptor
DTC B2585 00: Park Lamp Control CircuitDiagnostic Fault Information
Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
|---|---|---|---|---|
Park Lamp Relay Control | 1 | 1 | B2585 00 | -- |
1. Park, License, and/or Tail Lamps Malfunction | ||||
Circuit/System Description
Battery voltage is applied at all times to both the coil and switch sides of the PRK LAMP Relay. When the headlamp switch is placed in the PARK position, ground is applied through the park lamp switch signal circuit to the body control module (BCM). The BCM then applies a ground to the park lamp relay control circuit. This energizes the relay and applies voltage through both park lamp fuses and to all the park lamps.
Conditions for Running the DTC
| • | Battery voltage must be between 9-16 volts. |
| • | Park lamps ON. |
Conditions for Setting the DTC
DTC B2585 00 will set when the BCM detects a short to voltage in the park lamp relay control circuit.
Action Taken When the DTC Sets
When DTC B2585 00 is present, the park lamps will not operate.
Conditions for Clearing the DTC
| • | The condition responsible for setting the DTC no longer exists. |
| • | A history DTC will clear once 100 consecutive malfunction-free ignition cycles have occurred. |
Reference Information
Schematic Reference
Connector End View Reference
Description and Operation
Exterior Lighting Systems Description and Operation
Electrical Information Reference
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Testing
- Ignition OFF, disconnect the park lamp relay.
- Connect a test lamp between B+ and the control circuit terminal E5.
- Ignition ON, command the Parking Lamps ON and OFF with a scan tool. The test lamp should turn ON and OFF when changing between commanded states.
- If the circuit tests normal, replace the park lamp relay.
| ⇒ | If the test lamp is always ON, test the control circuit for a short to ground. If the circuit tests normal, replace the BCM. |
| ⇒ | If the test lamp is always OFF, test the control circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the BCM. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
| • | Control Module References for BCM replacement, setup, and programming |
