Removal Procedure
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
- Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation .
- Support the control arm with a jack stand.
- Disconnect the automatic level control air tube from the shock.
- Remove the lower shock absorber retaining bolts.
- Remove the trunk trim to gain access to the shock absorber upper mounting nuts.
- Remove the upper shock absorber cover.
- Remove the upper shock absorber retaining nuts.
- Remove the upper shock absorber reinforcement.
- Remove the shock from the vehicle.
Installation Procedure
- Install the shock, reinforcement, and the retaining nuts.
- Install the upper shock absorber cover.
- Install the trunk trim.
- Install the lower shock absorber retaining bolts.
- Connect the automatic level control air tube to the shock.
- Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
- Lower the vehicle.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the upper shock absorber retaining nuts to 25 N·m (18 lb ft).
Tighten
Tighten the lower shock absorber retaining bolts to 25 N·m (18 lb ft).
