Tools Required

J 24319-B Universal Steering Linkage Puller

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation .



3. Remove the lock nut (3) from the outer tie rod (1).



4. Loosen the jam nut (2) on the inner tie rod (1).



5. Using J 24319-B remove the outer tie rod from the steering knuckle.



6. Remove the outer tie rod (3) from the inner tie rod (1).

1. Install the outer tie rod (3) to the inner tie rod (1). Do not tighten the jam nut (2).



2. Install the outer tie rod (1) to the steering knuckle (2).




Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the outer tie rod lock nut (3).

Tighten
Tighten the tie rod lock nut to 30 N·m (22 lb ft) plus an additional 180 degrees.

4. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
5. Lower vehicle.
6. Adjust the toe alignment. Refer to Front Toe Adjustment .