Callout
| Component Name
|
|
Notice: Refer to Fastener Notice in the Preface section. Fastener Tightening Specifications:
Refer to
Fastener Tightening Specifications.
Tools Required
| • | J 24319-B
Steering Linkage and Tie Rod Puller |
| • | J 39549
Ball Joint and Tie Rod End Separator |
Preliminary Procedures
- Raise and support the vehicle. Refer to
Lifting and Jacking the Vehicle.
- Remove the front tire and wheel assembly. Refer to
Tire and Wheel Removal and Installation.
- Remove the brake rotor from the wheel hub/bearing. Refer to
Front Brake Rotor Replacement.
- Remove the wheel bearing/hub. Refer to
Front Wheel Bearing and Hub Replacement.
|
1
| Outer Tie Rod End Nut
Tip
| • | Use the
J 24319-B
to separate the tie rod end from the steering knuckle. |
| • | Always replace the tie rod end nut after it has been used. |
Tighten
30 N·m (22 lb ft) plus an additional 200 degrees |
2
| Outer Tie Rod End
|
3
| Strut to Steering Knuckle Nut (Qty: 2)
Tighten
147 N·m (108 lb ft) |
4
| Strut to Steering Knuckle Bolt (Qty: 2)
|
5
| Lower Ball Joint Nut
Tip
| • | Use the
J 39549
to separate the ball joint from the lower control arm. |
| • | Always replace the ball joint nut after it has been used. |
Tighten
30 N·m (22 lb ft) plus an additional 210 degrees |
6
| Steering Knuckle
Tip
Remove the steering knuckle from the vehicle. |
