Tools Required

J 45059 Angle Meter

1. Remove the crankshaft balancer. Refer to Crankshaft Balancer Replacement .
2. Disconnect the engine harness electrical connector (3) from the crankshaft position (CKP) sensor.



3. Remove the CKP sensor shield.



4. Remove the CKP sensor studs and sensor.

Notice: Refer to Fastener Notice in the Preface section.




1. Install the CKP sensor and studs.

Tighten
Tighten the studs to 20 N·m (15 lb ft) plus an additional 40 degrees using J 45059 .




2. Install the CKP sensor shield.



3. Connect the engine harness electrical connector (3) to the CKP sensor.
4. Remove the crankshaft balancer. Refer to Crankshaft Balancer Replacement .