Tools Required

1. Remove the drive belt. Refer to Drive Belt Replacement .
2. Remove the wheel house liner. Refer to Front Wheelhouse Liner Replacement .
3. Remove the torque converter covers. Refer to Torque Converter Cover Replacement .
4. Install the J 37096 to prevent the flywheel from turning.
5. Remove the crankshaft balancer bolt and discard the bolt.




Important: Do not separate the crankshaft pulley from the crankshaft balancer. Service the crankshaft pulley and the crankshaft balancer as an assembly.

6. Install the J 38197-A .
7. Remove the crankshaft balancer.
8. Remove the J 38197-A .

1. Coat the engine front cover seal contact area on the crankshaft balancer, and the seal surface with engine oil.
2. Install the crankshaft balancer.

Notice: Refer to Fastener Notice in the Preface section.

3. Install the new crankshaft balancer bolt. Use the J 45059 to prevent the flywheel from turning.

Tighten
Tighten the bolt to 150 N·m (111 lb ft) plus an additional 76 degrees using the J 45059 .

4. Remove the J 45059 .
5. Install the torque converter covers. Refer to Torque Converter Cover Replacement .
6. Install the wheel house liner. Refer to Front Wheelhouse Liner Replacement .
7. Install the drive belt. Refer to Drive Belt Replacement .
8. Perform the CKP system variation learn procedure. Refer to Crankshaft Position System Variation Learn .