Preliminary Procedures

1. Remove the wiper arms. Refer to Windshield Wiper Arm Replacement .
2. Remove the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement .
3. Remove the windshield frame reinforcement.
4. Disconnect the wiper transmission electrical connector from the main engine harness.

1

Windshield Washer System Module Bolt

Notice: Refer to Fastener Notice in the Preface section.

Tighten
9 N·m (80 lb in)

Tip

1. Raise the rearward edge of the module assembly out of the plenum panel first followed by wiper motor.
2. Tighten bolts in sequence as shown upon installation.

2

Windshield Washer System Module Bolt

Tighten
9 N·m (80 lb in)

3

Windshield Washer System Module Bolt

Tighten
9 N·m (80 lb in)

4

Windshield Washer System Module