Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .

Preliminary Procedure

1. Use a J 25070 Heat Gun in a circular motion to warm the roof panel joint finish molding prior to removal. Carefully clean the roof trough thoroughly with 100% isopropyl prior to bonding the new roof panel joint finish molding to the roof.
2. Ensure the roof panel trough is at least 19°C (66°F) prior to installing the roof panel joint finish molding to the vehicle.

1

Roof Panel Joint Finish Molding Assembly

Tip
Pull approximately 3 inches of the adhesive backed tape from the molding and begin installation at the forward edge working rearward.