Preliminary Procedure

Open the rear compartment lid in order to ease the removal and installation of the rear compartment lid lower molding.

1

Rear Compartment Lid Lower Molding

Procedure

1. Release the 2 outer edges of the molding from the rear compartment lid studs.
2. Remove the molding by lifting the molding upward at the center 4 studs.
3. Slide the molding off the top edge of the 4 center bull horn clips.
4. Slide the molding cross car in order to remove.

2

Bull Horn Clips (Qty: 6)

Procedure

1. Install the 4 bull horn clips to the center of the rear compartment lid over the rear compartment lid studs with the horns on the clips facing downward.
2. Slide the clips onto the keyhole slots in order to secure.
3. Position the bottom edge of the molding onto the horns of the bull horn clips.
4. Lift and secure the top edge of the molding to the bull horn clips.
5. Slide the molding from left to right securing the molding to the four center clips.
6. Snap fit the 2 outer clips by pressing on the face of the molding to secure.