Generator Replacement V8

1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
2. Remove the radiator. Refer to Radiator Replacement.
3. Remove the drive belt. Refer to Drive Belt Replacement.
4. Disconnect the engine wiring harness electrical connector (5) from the generator.



5. Reposition the starter solenoid cable protective boot (1) at the generator.
6. Remove the generator terminal nut (2).
7. Remove the starter solenoid cable terminal (3) from the generator.



8. Remove the generator bolts.
9. Reposition the engine ground cable.
10. Remove the generator.

1. Position the generator to the engine.
2. Install the generator bolts finger tight in the following sequence.

2.1.	Upper bolt

2.2.

Side bolt

2.3.	Lower bolt

Notice: Refer to Fastener Notice in the Preface section.

3. Tighten the generator bolts.

Tighten
Tighten the bolts to 50 N·m (37 lb ft).




4. Install the starter solenoid cable terminal (3) to the generator.
5. Install the generator terminal nut (2).

Tighten
Tighten the nut to 12 N·m (106 lb in).

6. Position the starter solenoid cable protective boot (1) at the generator.



7. Connect the engine wiring harness electrical connector (5) to the generator.
8. Install the drive belt. Refer to Drive Belt Replacement.
9. Install the radiator. Refer to Radiator Replacement.
10. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.

Generator Replacement RPO L26

1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
2. Remove the intake manifold cover. Refer to Intake Manifold Cover Replacement .
3. Remove the drive belt. Refer to Drive Belt Replacement .
4. Remove the generator brace bolt and nut.
5. Remove the generator brace.



6. Disconnect the engine harness electrical connector from the generator.



7. Reposition the starter cable boot.
8. Remove the generator terminal nut.
9. Remove the starter cable from the generator.



10. Remove the generator front bolt.
11. Remove the generator rear bolt and stud.
12. Remove the generator.

1. Set the generator into position on the engine.
2. Install the generator front bolt.

Notice: Refer to Fastener Notice in the Preface section.

3. Install the generator rear stud and bolt.

Tighten
Tighten the bolt/stud to 50 N·m (37 lb ft).




4. Install the starter cable to the generator.
5. Install the generator terminal nut.

Tighten
Tighten the nut to 20 N·m (15 lb ft).

6. Position the starter cable boot.



7. Connect the engine harness electrical connector to the generator.



8. Install the generator brace.
9. Install the generator brace bolt and nut.

Tighten

•	Tighten the bolt to 25 N·m (18 lb ft).

•	Tighten the nut to 50 N·m (37 lb ft).

10. Install the drive belt. Refer to Drive Belt Replacement .
11. Install the intake manifold cover. Refer to Intake Manifold Cover Replacement .
12. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .