Preliminary Procedures

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the front tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
3. Remove the front stabilizer shaft link. Refer to Stabilizer Shaft Link Replacement .

1

Notice: Refer to Fastener Notice in the Preface section.

Front Lower Ball Joint Nut

Tip

Tighten
30 N·m (22 lb ft) plus an additional 210 degrees

Special Tools

J 39549 Ball Joint and Tie Rod End Separator

2

Front Control Arm Front Nut (Qty: 2)

Tighten
150 N·m (111 lb ft)

3

Front Control Arm Front Bolt (Qty: 2)

Tip
Remove the bolts from the control arm bracket.

4

Front Control Arm Rear Nut

Tip
Do not tighten the control arm nut until the weight of the vehicle is supported by the control arm. The vehicle needs to be sitting at normal trim height.

Tighten
157 N·m (116 lb ft)

5

Front Control Arm Rear Bolt

Tip
Remove the bolt from the control arm.

6

Front Control Arm

Tip
Remove the control arm from the vehicle.