GM Service Manual Online
For 1990-2009 cars only

Circuit Description

The EEPROM write error detection is handled inside the control module. No external circuits are involved.

Conditions for Running the DTC

The module runs the program in order to detect a write error whenever the module writes to the EEPROM. The only requirements are voltage and ground. This program runs even if the voltage is out of the valid operating range.

Conditions for Setting the DTC

The module first writes information to a cell, or address, in the EEPROM. The module then reads the information and compares the information to what was sent to the address. If they do not match after 3 consecutive attempts, the module sets this DTC.

Action Taken When the DTC Sets

The module tried to write to the memory location 3 times, if the write is not accomplished, the DTC is set.

Conditions for Clearing the DTC

    • A current DTC clears when the malfunction is no longer present.
    • A history DTC clears when the module ignition cycle counter reaches the reset threshold, without a repeat of the malfunction.

Diagnostic Aids

    • This DTC may be stored as a history DTC with out affecting the operation of the module. If stored only as a history DTC and not retrieved as a current DTC, do not replace the module.
    • If this DTC is retrieved as both a current and history DTC, replace the module.

Step

Action

Yes

No

1

Did you perform the Diagnostic System Check for the system exhibiting the symptom?

Go to Step 2

Go to Control Module References for the applicable Diagnostic System Check

2

  1. Install a scan tool.
  2. Turn ON the ignition, with the engine OFF.
  3. Retrieve DTCs.

Is the DTC retrieved as a current DTC?

Go to Step 3

Go to Diagnostic Aids

3

Important: Perform the programming or setup procedure for the module if required.

Replace the control module setting the DTC as current. Refer to Control Module References .

Did you complete the replacement?

Go to Step 4

--

4

  1. Use the scan tool in order to clear the DTCs.
  2. Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text.

Does the DTC reset?

Go to Step 2

System OK