Step | Action | Yes | No |
|---|---|---|---|
Schematic Reference: Instrument Cluster Schematics or Release Systems Schematics Connector End View Reference: Displays and Gages Connector End Views | |||
1 | Did you review the Luggage Compartment Description and Operation, and perform the necessary inspections? | Go to Step 2 | |
2 | Close the rear compartment. Is the trunk ajar message/indicator illuminated? | Go to Step 3 | Go to Testing for Intermittent Conditions and Poor Connections |
3 | Disconnect the rear compartment lid latch. Is the trunk ajar message/indicator illuminated? | Go to Step 4 | Go to Step 5 |
4 | Test the rear compartment lid ajar switch signal circuit for a short to ground. Refer to Circuit Testing and Wiring Repairs . Did you find and correct the condition? | Go to Step 8 | Go to Step 7 |
5 | Inspect for poor connections at the harness connector of the rear compartment lid latch. Refer to Circuit Testing and Wiring Repairs . Did you find and correct the condition? | Go to Step 8 | Go to Step 6 |
6 | Replace the rear compartment lid latch. Refer to Rear Compartment Lid Latch Replacement . Did you complete the repair? | Go to Step 8 | -- |
7 | Replace the instrument panel cluster (IPC). Refer to Control Module References for the IPC replacement, setup, and programming. Did you complete the repair? | Go to Step 8 | -- |
8 | Operate the system in order to verify the repair. Did you correct the condition? | System OK | Go to Step 2 |
