For 1990-2009 cars only
Removal Procedure
- Remove the end cap on the side of the instrument panel (I/P).
- Pull out to remove the tweeter speaker wire clip from the I/P.
- Disconnect the speaker wire from the I/P electrical harness.
- Remove the windshield garnish molding. Refer to Windshield Pillar Garnish Molding Replacement .
- Pull the speaker wire up through the I/P.
- Remove the speaker from the vehicle.
Installation Procedure
- Position the speaker on the I/P.
- Slide the wire down through the I/P to the end cap.
- Connect the wire to the I/P harness.
- Press the wire clip onto the I/P.
- Press the end cap onto the I/P.
- Press in the speaker (1) until it is fully seated on the garnish molding.
- Install the windshield garnish molding (2). Refer to Windshield Pillar Garnish Molding Replacement .
