The rear compartment lid can be released by holding the Driver or Passenger door lock switches in the UNLOCK position for 1.5 seconds or by pressing the rear compartment lid release button on the remote keyless entry transmitter. The gear selector must be in PARK in order for the rear compartment to release.

The driver or passenger power door lock switches supply the signal to the body control module (BCM) which when commanded supply battery positive voltage through the latch motor voltage control circuit to the rear compartment lid latch. The rear compartment lid latch, which is grounded to G302, then releases the rear compartment lid so that it may be manually raised to an open position.

Schematic Reference

Release Systems Schematics

Connector End View Reference

Vehicle Access Connector End Views

Electrical Information Reference

1. Verify the power door locks operate properly from the interior power door lock switches

⇒	If the power door locks do not operate properly, refer to Power Door Lock Inoperative - Driver Door

2. Ignition ON, command the rear compartment lid to release with the scan tool output controls. The rear compartment lid should open.

1. Ignition OFF, disconnect the harness connector at the rear compartment lid latch.
2. Ignition OFF, test for less than 1.0 ohm of resistance between the switch ground circuit terminal 3 and ground.

⇒	If greater than the specified range, test the ground circuit for an open/high resistance.

3. Connect a test lamp between the control circuit terminal 4 and the ground circuit terminal 3.
4. Ignition ON, command the rear deck lid release ON and OFF with a scan tool. The test lamp should turn ON and OFF when changing between the commanded states.

⇒	If the test lamp is always ON, test the control circuit for a short to voltage. If the circuit tests normal, replace the BCM.

⇒	If the test lamp is always OFF, test the control circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the BCM.

5. If all circuits test normal, test or replace the rear compartment lid latch.

Static Test

1. Ignition OFF, disconnect the harness connector at the rear compartment lid latch.
2. Test for 5-8 ohms of resistance between the control terminal 4 and the ground terminal 3 of the rear compartment lid release actuator.

⇒	If not within the specified range, replace the rear compartment lid latch.

3. Test for infinite resistance between each terminal and the rear compartment lid latch housing/case.

⇒	If not the specified value, replace the rear compartment lid latch.

Dynamic Test

Important: Apply power and ground to the rear compartment lid latch for no more than 2 seconds at a time or the actuator could be damaged.

Install a 20-amp fused jumper wire between the voltage control circuit terminal and 12 volts. Momentarily install a jumper wire between the ground terminal and ground. The deck lid should open.

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.