GM Service Manual Online
For 1990-2009 cars only

Diagnostic Instructions

    • Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
    • Review Strategy Based Diagnosis for an overview of the diagnostic approach.
    •  Diagnostic Procedure Instructions provides an overview of each diagnostic category.

Diagnostic Fault Information

Circuit

Short to Ground

Open/High Resistance

Short to Voltage

Signal Performance

Accessory Voltage

1

1

--

--

Steering Column Key Cylinder Lock Solenoid Control

1

1

2

--

Ground

--

1

--

--

1. Ignition key will not turn to OFF with vehicle in park.

2. Ignition key will turn to OFF with vehicle out of park.

Circuit/System Description

If the vehicle is equipped with automatic transmission and a floor mounted console gear shift, it has an electronic park lock system (EPL). The EPL system purpose is to prevent the ignition key from being turned to the OFF position when the transmission is in any position other than PARK and the vehicle may still be moving. The EPL system consists of an ignition lock cylinder control actuator, and a park position switch that is located in the A/T shift lock control switch. The ignition lock cylinder control actuator contains a pin that is spring loaded to mechanically prevent the ignition key cylinder from being turned to the lock position when it is not energized. The park position switch receives voltage from the accessory voltage circuit when the ignition is turned ON. When the transmission shift selector is in PARK, the park position switch closes and energizes the ignition lock cylinder control actuator retracting the pin, allowing the ignition switch to be turned OFF. If vehicle power is lost, and/or the transmission is not in the park position the operator will not be able to turn the ignition key to the lock position and will not be able to remove the ignition key from the column.

Diagnostic Aids

    • Manually pushing in the ignition lock cylinder control actuator pin will allow the ignition key to be turned to OFF.
    • The park switch is part of the shift lock solenoid/switch assembly.

Reference Information

Schematic Reference

Ignition Lock Schematics

Connector End View Reference

Power and Grounding Connector End Views

Description and Operation

Electronic Park Lock Description and Operation

Electrical Information Reference

    •  Circuit Testing
    •  Connector Repairs
    •  Testing for Intermittent Conditions and Poor Connections
    •  Wiring Repairs

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector at the ignition lock cylinder control actuator.
  2. Test for less than 1.0 ohm between the ground circuit terminal B and ground.
  3. If greater than the specified range, test the ground circuit for an open/high resistance.
  4. Connect a test lamp between the control circuit terminal A and ground.
  5. Ignition ON, transmission shift selector in PARK then out of PARK. The test lamp should turn ON and OFF when changing between PARK then out of PARK.
  6. If the test lamp stays illuminated, test the control circuit for a short to voltage. If the circuit tests normal, test or replace the park switch.
    If the test lamp does not illuminate, test the control, and park switch accessory voltage circuits for a short to ground or open/high resistance. If the circuits test normal, test or replace the park switch.
  7. If all circuits test normal, test or replace the ignition lock cylinder control actuator.

Component Testing

Park Switch

  1. Ignition OFF, disconnect the harness connector at the park switch.
  2. Test for infinite resistance between the output terminal and the input terminal with the switch in the open position.
  3. If not the specified value, replace the park switch.
  4. Test for less than 1 ohm between the output terminal and the input terminal with the switch in the closed position.
  5. If greater than the specified value, replace the park switch.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

    •  Transmission Control Replacement
    •  Ignition Lock Cylinder Control Solenoid Replacement