1

Rearview Mirror Support Wire Cover

2

Rearview Mirror Support Screw

Notice: Refer to Fastener Notice in the Preface section.

Procedure

1. Disconnect the electrical connector from the mirror.
2. Adjust the mirror to the full upward position.
3. Loosen the screw in order to remove the mirror from the button assembly.
4. Slide the mirror assembly in an upward motion in order to remove.

Tighten
1.8 N·m(16 lb in).

3

Rearview Mirror

Procedure

1. Position the center bottom of the mirror mount against the windshield at the top of the support button.
2. Slide the base of the mirror onto the button.
3. Refer to Control Module References for programming and setup information.